Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

Link ECU Ballast Resistor (BAL4)For use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 4 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 6. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the

If you are planning to run a drive by cable configuration on our terminated LS harness you will need this part

is to check whether pins A1-3 are populated

This ECU is designed for the R50-R53 Tritec 1

with no alteration of the factory wiring loom required for the models listed below

Requires 'A' & 'B' Looms or 'A' & 'B' Pin Kits

Bosch Junior Timer / Jetronic (Male) to USCar (Female) Adapter   Commonly used when upgrading to fuel injectors with the newer USCar connector and your wiring loom has Bosch Junior Timer/Jetronic/EV1 connectors

stranded wires

PIN C = Signal

E-throttle is faster responding

from environmental influences and weathering for up to 3 months

Easy to install

ECU does not fit in the original housing of non-turbo cars

Exchange/Return Notes